Solidyne AUDIMAX 362, Руководство пользователя

Страница: 5 / 19

SOLIDYNE
AUDIMAX 362
Pág. 5
Chapter 1 – Installation
2.1 What’s in the box?
The AudiMax-362 packaging include:
1 AudiMax-362 Processor (include supports for
rack montage).
1 User’s manual.
1 Power cord.
1 Guarantee agreement.
4 self-adhesive rubber supports.
2.2 Generalities
Please read carefully the following
recommendations:
•
Audimax 362 processors are designed for rack
montage in 19” standard racks. Also it can be
used on a table or desktop, quitting the lateral
supports.
•
The room temperature must be between 5 and
40°C (41°/104° F). Avoid the direct solar ray
incidence on the equipment. Avoid the proximity
of heat sources and high electromagnetic fields
(high power transformers, motors, etc). 462-MKII
have internal protection against RF fields, that
allows assembly it next to AM/FM RF amplifiers.
•
The installation in very humid places or with saline
atmosphere will have to be avoided, since they
will can cause corrosion in the printed circuit
board and electronic component.
2.3 Power source
Verify the correct position of the AC120/220
voltage switch, located on the rear panel. The
variation of the AC voltage must be smaller than
10%. Otherwise, use tension stabilizers of fast
action.
The on/off switch locates on the rear panel.
2.4 Wiring
Use shielded twisted pair audio cables of good
quality for audio connections (microphone type).
Input and output connectors are XLR type (as is
standard, female for the inputs and male for the
outputs). Connect as the following table indicates:
1 Tierra
2 Señal (+)
3 Señal (-)
Conectores de entrada y salida
Inputs and outputs are
electronically balanced
.
Inputs come from factory in "bridging" mode, with
impedance bigger than 10 Kohms. They must be
connected to 600 ohms console’s outputs. For old
consoles that only works with real 600 ohms loads
at the output, place a 620 ohms resistor inside the
XLR input connectors, connected between pins 2
and 3.
2.5 MPX Output
For MPX output use 52 ohms coaxial cable. The
connector is a BNC. The maximum length for this
cable can be 50 meters.
Is very important to have a adequate ground
installation. In case of doubt, refers to your
Solidyne dealer.
When use the MPX input of the transmitter, make
sure that the internal pre-emphasis stage is
disabled (flat response between 20 – 100 KHz).
2.6 Humming
If some residual humming appears when the
system is started up; turn off the unit. If humming
disappears, check the 462 input connections. If
the humming still here; unplug the MPX cable. If
humming ends, this indicates that a problem
occurs with the ground connections.
Nevertheless, this problem rarely can occur since
the Audimax’s MPX output is differential type,
where the BNC connector has floating GND to
cancel possible humming.