Solid State Logic Nucleus2, Руководство пользователя, Страница: 24 / 58

IP
MIDI C
ONFIGURATION
The ipMIDI driver enables your DAW to send and receive MIDI control data via the network connection, and must be
configured to match the requirements of Nucleus
2
before it can be used.
Mac
Once the driver has been installed and you have logged back in, use the Finder to navigate to the Utilities folder (in
Applications ). Double-click Audio MIDI Setup , select MIDI Devices and double-click on the ipMIDI icon. Set the number
of MIDI ports to 6 in the resulting pop-up.
Windows
Once the computer has restarted after installing the driver, right-click on the ipMIDI icon in the Task Bar , select ipMidi -
MIDI over ethernet
and set the number of MIDI ports to 6 in the resulting pop-up.
MIDI Port Mapping
MIDI control for the three Nucleus
2
Layers is split across the six ipMIDI ports which means that your DAW must be
configured to match the following:
Note that CC Layers only use the first MIDI port in their layer. All CC data is sent on MIDI Channel 1.
Setting which ipMIDI ports the DAW should use is performed using the MIDI controller configuration page of your DAW.
Below and overleaf are two examples using Pro Tools 8 and Logic Pro 9.
Pro Tools
In the Setup menu, click on Peripherals and select the MIDI Controllers tab.
For MIDI controllers 1 and 2, select ‘ HUI ’ as the MIDI controller ‘ Type ’ and assign the MIDI ports for this layer’s DAW to the
two MIDI controllers, as listed in the table above.
As an example, if Pro Tools has been assigned to Layer 1 (so using ipMIDI ports 1 & 2), the MIDI Controllers tab should
look as shown.
Nucleus
2
DAW Layer Nucleus
2
Channels ipMIDI port
1
1 to 8 1
9 to 16 2
2
1 to 8 3
9 to 16 4
3
1 to 8 5
9 to 16 6
Page 20 Nucleus
2
User Guide