PRODUCT MANUAL
Magro RGB-W Wireless LED Wall Controller / Wall Switch
Contact Us: 425.582.7533
www.SolidApollo.com
page 4
™
Product Wiring and Installation
Installation & Pairing of the Magro Controller
Once the wiring of the Receiver to a Power Supply and LED Fixture is complete, the only remaining thing is to install the Magro and pair it to the
Receiver.
1.
Preparation for mounting the Magro:
a. Detach the Magro RGBW Wireless Controller from the Magnetic
Wallplate and open the battery compartment at the back.
b. Remove the battery and take out the plastic piece under it.
c. Return the battery into its compartment (in the same position
as it was removed) and place the cover.
Please Note:
The small blue indicator LED on the top left corner
should blink if any button is pressed.
a
b
2.
Mounting the Controller to a Wall Gang Box:
a. Install the Magnetic Wallplate on any available gang box using the screws provided (it can also be installed on any flat surface).
b. Install the faceplate on the secured Magnetic Wallplate and insert the Magro RGBW Wireless Controller.
3.
Pairing the Controller to the Receiver:
a. Push the “Learning Key” button on the Receiver once.
b. Push the ON button (depicted by a powered bulb icon) on the
Magro. The lights would flash.
a
b
Learning Key
Button
ON
Button
