USING YOUR AIR CONDITIONER
Electronic Control Panel & Remote Control
1.
Power Button:
Turns the air conditioner on and
off
.
2.
Digital Display:
Under ON status without timer
setting,the operation mode is Cool, Energy
Saver
or Dry mode,
and the set temperature will be
displayed.
Under ON status without timer setting, the
opera-
tion mode is
F
an mode and the
room temperature
will be displayed
.
Time will be displaye
d
under timer setting or timer
preview
.
3.
Temperature Set:
Use these buttons on the con-
trol panel and remote to increase or decrease the
Set Temperature (the desired room temperature)
in cooling
,
energy saver
and dry
mode.
4.
Timer Set:
Use these buttons on the control
panel and remote to set the Timer. Each press of
the
buttons will increase or de
crease the
timer. For timer instructions see #7.
5.
Fan Speed
: Use the fan speed but
ton to change
the fan speed. Choose between
low, medium,
and
high.
6.
Mode Button:
Press the mode button to cycle
through the various modes:
Energy
Saver, Dry
(Dehumidifier)
, Fan and Cool
.
7.
Auto-on Timer:
When the air conditioner is off, it
can be set to automatically turn on in
1
-24 hours
at the previous set mode and fan setting. To set
the Auto-on Timer, press the
TIMER
button on th
e
unit or remote control.
The timer can be set in
1
The
hour indicator on the bottom right of the dig-
Auto-off Timer:
When the air conditioner is on, it
can be set to automatically turn off in
1
-24
hours.
To se
t
the Auto-off Timer, press the
TIMER
button on the unit or remote control.
The timer
can be set in
1
hour increment
.
The
hour indicator on the bottom right of the dig-
•
To see the remaining time, press the
TIMER
Button. To change the timer setting use the
▲
/
▼
on the unit or the +/- buttons on the
remote.
•
During preview of timer or timer setting,
press Timer button on the panel or remote
8.
Filter
Reset
:
After the fan rotates for 250 total
hours, the filter check light will turn on to remind
the user to clean the filter. Press the Filter
Reset
button once the filter is cleaned to reset the re-
minder.
NOTE: This display always shows the room temperature
in Fan
Mode
except when setting the Set temperature or the Timer
Normal Operating Sounds
•
You may hear a pinging noise caused by water
hitting the condenser, on rainy days, or when the
humidity is high. This design feature helps re-
move moisture and improve efficiency.
•
You may hear the thermostat click when the com-
pressor cycles on and off.
•
Water will collect in the base pan during rain or
days of high humidity. The water may overflow
and drip from the outside part of the unit.
•
The fan may run even when the compressor is
not on.
hour increment
.
controller to cancel the timer setting.
9
▲
/
▼
ital display will start flashing.
ital display will start flashing.
To switch between Celsius/Fahrenheit
display,
press the button
s
at the same time
.
▲
/
▼
Point the remote control at the
air conditioner when sending instruction
to the
unit
.
9
.
Signal Receiver
:
