SAFETY INFORMATION
Use appliance only for intended household use as described in this
manual. Any other use not recommended by the manufacturer may
cause fire, electric shock or injury to persons.
Do not use outdoors.
Do not place anything on top of the unit.
Do not attempt to repair or adjust any electrical or mechanical
functions on this unit. Doing so will void the warranty.
There are no user-serviceable parts inside this unit. All servicing
should be performed by qualified Solenco-approved engineers.
WARNING: To reduce the risk of fire or electric shock, do not use this
fan with any solid-state speed control device.
TECHNICAL SPECIFICATIONS
Rated Voltage
AC 230V, 50Hz
Rated Power
50W
Noise level
30dB (L), 40dB (M), 50dB (H)
UV Light
Wavelength: 254 nanometres
Lamp life: Approx. 20 000 hours
Weight
4.5kg
Dimensions (mm)
390 x 145 x 428
Coverage area
Approx. 20
– 40m
2
4
6
3
4.
“
UV-C
” BUTTON: Press this button to switch the UV lamp on
or off.
5.
“
TIMER
” BUTTON: When pressing this button, the unit can be
timed to operate at intervals of 2 hours, 4 hours and 8 hours.
The unit will stop automatically when the selected operating
time has been reached. A warning light automatically indicated
the remaining operating time. To select the continuous
operating mode, press the button repeatedly until no indicator
lights are lit.
IMPORTANT: Switch the unit off and unplug it when not in use.
INSTALLING & REMOVING FILTERS
REPLACE FILTER INDICATOR
The REPLACE FILTER light will flicker continuously indicating that it is
time to replace the filter. Replace the filter according to the instruction then
press the REPLACE FILTER button and hold for 5 seconds to restart the
system. The light will stop flickering.
* The Combination Filter is a single unit with multiple layers: the Pre-Filter,
Activated Carbon Filter and HEPA filter. This filter lasts approximately 6
months.
1.
Open the front cover from the bottom of the unit.
2.
Remove the Combination filter by pulling the two strips
3.
Insert new Combination filter. Consult the strips on the filter for
correct installation direction.
4.
Reattach the extra Pre-filter to the combination filter.
5.
Reattach the front cover of the unit and securely latch into place.
6.
Press and hold the REPLACE FILTER button for 5 seconds to reset
Filter Change Indicator.
This product has received the Seal of
Approval from the Allergy Foundation of
South Africa. It has been scientifically
tested by AFSA and/or independent
laboratories to prove its efficiency at
reducing or removing allergens or
chemical content from the environment.
Due to patient variation, however, use of
these products cannot be guaranteed to
reduce symptoms in all allergy sufferers.
