Installation and Operation Manual (Rev B)
PVI 10KW, 13KW, 15KW
18
DOCR-060011
Measurements Menu
This displays the data retrieved from the inverter. Use the
buttons to scroll up and down
through the list.
Pressing
will take the screen back to the start menu.
AC Energy
Cumulative AC Energy (kWh)
AC Power
AC Power output (W)
AC Voltage
AC Voltage, Three-phase (V)
AC Freq.
AC Frequency (Hz)
AC Current (average)
AC Current, Three-phase average (A)
DC Voltage
DC Voltage (V)
Heat Sink
Heat Sink Temperature (
°
C)
Note: data will only be available when inverter is awake and communicating.
Set Inverter Menu
This displays inverter parameters, some of which may be modified with the keypad. Use the
buttons to scroll up and down through the list.
Pressing
will take the screen back to the
start menu.
1.
Power Disable
Temporarily disables the AC output of the inverter
2.
Inverter ID
Serial port address/ID of the inverter
3.
Baud Rate
Serial port baud rate (19200 or 9600)
Note: data is only available when inverter is operating.
Monitor Menu
Displays monitor settings that may be modified with the keypad.
1.
LAN
Local Area Network configuration, applicable only for SolrenView monitoring
a.
DHCP Mode
See SolrenView manual on DHCP
b.
Static/Fallback IP
If DHCP is turned on, this is then used as the fallback IP
c.
Gateway IP
IP address of LAN’s default gateway
d.
Netmask
Subnet mask
2.
Date/Time
Manual time set. This may be overwritten by scheduled NIST updates.
3.
Reboot
Reboots the monitor
4.
Remote SRV
This starts the transmit process necessary for SolrenView monitoring.
Note: Enabling this option when SolrenView service has not been purchased will
result in unnecessary wear on the storage memory.
5.
Reset SRV
Settings are cleared to factory defaults. Caution: This will also
clear Revenue-grade KYZ counters.