NOTE
: do not overtighten the bands – they should be snug enough to keep the unit
steady but allow the position to be adjusted.
iii.
Place the inside tooth washer on the molded flange.
iv.
Thread the bolt through the bracket and attach washers and nut.
NOTE
: Do not overtighten the nut – it should be snug enough to keep the unit steady
but allow the position to be adjusted.
c.
Connecting the unit to power and customer network
Using the supplied power cord, connect the power adapter to AC power.
WARNING: The power adapter is not rated for outdoor use.
Connect a shielded twisted pair (STP, Category 5 or better) cable to the connector marked OUT on the adapter. This cable
will deliver both power and network access to the unit – it should be long enough to reach the SS in its permanent location.
The power is carried on the unused Cat5 signal lines (pins 4,5,7,8). Be sure these lines are correctly connected
