4:Insert the tripped wire into the hole of the terminal block.
5: Screw down the screws on the terminal block.
6: Connect the terminal block.
a. Insert the male terminal into the female rerminal on the inverter.
b.Screw down the two screws on the both side of the terminal block.
7: Install the communication lid.
8: Tight the connection of the cable gland.
a. Slide the seal to the body of the cable gland,insert the seal into the body
of the cable gland.
b. Slide the cable nut to the body of the cable gland,rotate the cable nut to
tight the connection.
5.7 Run the inverter
Start inverter after checking all below steps:
• Check that the device is fixed well on the wall.
• Make sure all the DC wirings and the AC wirings are completed.
• DC connectors which are not used should be sealed by cover.
• Turn on the external AC and DC connector.
• Turn on the DC switch to the “ON” position.
Start inverter
Inverter will start automatically when PV panels generate enough energy.
•
• Check the status of LED and LCD screen, the LED should be green and the
LCDscreen should display the main interface.
• If the LED is not green, please check the below:
- All the connections are right.
- All the external disconnect switches are closed.
- The DC switch of the inverter is in the “ON” position.
Please set the inverter if it is the first time to start up.
Above steps is for the regular start up of the inverter. If it is the
first time to start up the inverter, you need to setup the inverter ..
NOTE
!
WARNING
!
Power to the unit must be turned on only after installation work
has been completed. All electrical connections must be carried
out by qualified personnel in accordance with legislation in force
in the country concerned.
6 Operation Method
6.1 Control panel
A
B
C
D
F
G
H
I
E
31
30
6 Operation Method
5 Installation
