Bathroom Ventilation Kit
Product Installation Guide
Parts List
Ventilation grille
assembly
Ventilation housing
6 x Screw backing tabs
Ventilation screen
100mm in-line fan motor assembly
Single phase induction motor
Spring operated, non-return
flap to prevent backdraughts
Mounting bracket
Ducting (two x 3 metre lengths)
Soffit/fascia external exit vent
Integral timer
Please note and understand the following before beginning
installation:
Pull switch
6A 2-way ceiling switch, can also be
wired as 1-way (BS EN 60669-1)
Read through this installation guide and the separate
instructions provided with the fan motor. If you have any
questions, please contact the supplier before commencing
installation.
The Solatube Bathroom Ventilation Add on Kit is intended for
use solely as a component of Solatube Daylighting Systems
and should be used only in the manner intended by the
manufacturer.
This unit is for general ventilating use only in bathrooms, toilets,
shower rooms and utility rooms. It is not suitable for use in
kitchens.
Electrical wiring must be carried out by suitably qualified
persons, and in accordance with all applicable codes and
standards, including fire-rated construction.
Solalighting Limited
(seller) assumes no responsibility or obligation whatsoever for
the failure of an architect, contractor, installer, or building owner
to comply with all applicable laws, ordinances, building codes,
electrical codes, energy codes, fire and safety codes and
requirements, roof warranties and adequate safety precautions.
Before installing or servicing the unit, switch off power at the
consumer unit and take measures to prevent power from being
switched accidentally, eg lock it or securely fasten a prominent
warning label to the consumer unit to indicate it must not be
switched on.
Exhaust fans must always be vented to the outdoors.
If this unit is to be installed over a bath or shower, the circuit
must be marked as appropriate for the application and be
connected to a circuit breaker or trip switch and comply to
current IEE regulations.
Never place a switch where it can be reached from a bath or
shower.
Do not use this fan with any solid-state speed control device.
This guide is for installing the Solatube
Bathroom Ventilation Kit as an add-on to the
Solatube 160 DS Daylighting System (250 mm
diameter). The optional Solatube Electric Light
Add-on Kit may also be installed with the
Solatube Bathroom Ventilation Kit. Please refer
to the installation guide for the Solatube
Brighten Up
Series, and, if using, the Solatube
Electric Light Add-on Kit installation guide to
complete your installation.
Options
(included only if specified)
Universal pitched roof-
mounted exit vent
Solatube Electric Light
Add-on Kit
ML-INST-BVK14
