Solartron 1253A, Руководство по эксплуатации

Страница: 109 / 144

[Chapter 9]
1253 Op Man_DA
9.5
2.6 GROUP 6: ILLEGAL INPUT / OUTPUT MANIPULATION
CODE
60
61
Explanation
Attempt made to change input / output device during a learn
sequence.
Attempt to change operating conditions from a non-enabled I/O
device. For example, the keyboard attempts to send commands while
the instrument is under ‘local lock-out’ GPIB control. For more
information on states when various devices are enabled see Chapter
8, Remote Control.
2.7 GPOUP 7: SYSTEM
CODE
70
71
73
74
75
76
Explanation
Out of memory. No further memory is available for the operation
attempted. Delete unwanted programs, or reduce program to make
more room.
Power independent memory corrupted.
Calibration constants in error; l out of 3. One out of the three
internal copies of the calibration constants is corrupted. The 1253 is
still usable and measurements are valid, but contact a Solartron
service facility.
Calibration constants in error; 3 out of 3. All of the three internal
copies of the calibration constants are corrupted. The 1253 is still
usable but measurement accuracy is not guaranteed. Contact a
Solartron service facility immediately.
Commands not allowed if not in ‘calibration mode’. The 1253 must be
set internally before calibration commands can be used. See
Technical Manual.
Offsets or multipliers out of range. Attempted calibration has failed.
See Technical Manual.
2.8 GROUP 8: MEASUREMENT VALIDITY
CODE
81
Explanation
Overload
2.9 GROUP9: SYNCHRONIZER
CODE
94
Explanation
Synchronizer not ready or synchronizer fault 1, 2 or 3 has occurred.
See Technical Manual.