Electrical requirement
•
The module should be installed in the zone of
confident reception of GPS.
•
When using three-phase or single-phase
alternating-voltage motors with 110 or 220
volts supply, it is necessary to install a relay.
The current of the motors will not be
controlled. To do this, you must install an
additional current protection.
•
The control is designed for DC motors. The
motors installed in the drives must have the
same supply voltage. The load current of the
drives along both axes must be close to each
other.
•
The power supply of the module must be from
a separate source with a galvanic isolation!
•
Sensor leads should not be near power lines.
•
It is recommended that shielded wires be used
to connect actuators and sensors or a pigtail
retinue.
•
The power supply voltage must not exceed the
supply voltage range. Power supply from 12V
to 30V (and version HV with power from 12V
to 55V).
•
When using SOLARSAN-SLAVE, check for a
sure signal passing through the radio. Checking
the work of SOLARSAN - SLAVE on a double
delete. To increase the range, stretch the spiral
antenna of the receiver and transmitter.
•
At the moment of motion of the drives, set the
current threshold so that there is no overload
signal.
•
Install the light sensor in a place where there is no shadow. As a light sensor it is recommended to use a photo-
resistor with a rating of 10 kOhm.
•
When using the module indoors, in an iron box or under a canopy, install an external GPS antenna.
•
The anemometer is used with an analog output. To connect an anemometer with a frequency output, use a
converter.
•
The computer is connected to the module configuration only when the power is off. (и версию HV с
питанием от 12V до 55V).
Scanning drive
The learning button is used to scan the drives and
save coordinates.
The button is only available when GPS has
determined the coordinates and there is no movement
of the drives. When you press the button, a short
confirmation tone will sound.
After the "PROG" button is pressed - SOLARSAN-
GPS will remember the coordinates, and start
scanning the drives. The procedure is fully automatic
and can take up to 42 * 4 minutes depending on the
gear unit type. You can stop the procedure only by
turning off the power. After scanning, the module will
store the values in non-volatile memory and will
remember the parameters even when the power is
turned off. Confirming the end of the scanning
procedure will sound two beeps and the module will
reboot.
After training, SOLARSAN-GPS goes into automatic
control mode and does not require monitoring.
