Solaris SMART 54, Руководство пользователя

Страница: 4 / 9

SOLARIS® SMART54™
6 7
SOLARIS® SMART54™
INSTALLATION
The fixture is designed for indoor use only and must be used in a dry location with adequate
ventilation. Ensure that none of the fixture’s ventilation slots are blocked and ensure that the
fixture is fastened to a secure structure or surface. Do not use the fixture to illuminate sur -
faces less than 8 m (appx 26ft.) from the fixture.
FASTENING THE FIXTURE TO A FLAT SURFACE
The fixture can be fastened to a hard, fixed, flat surface that is oriented at any angle. Ensure
that the surface and all fasteners used can support at least 10 times the weight of all fixtures
and equipment they will support. Fasten the fixture Securely. Do not place it on a surface or
leave it where it can be moved or fall over. If you install the fixture in a location where it may
cause injury or damage if it falls, secure it as directed below with a securely anchored safety
cable that will hold the fixture if the primary fastening method fails.
MOUNTING THE FIXTURE ON A TRUSS
The fixture can be clamped to a truss or similar rigging structure in any orientation. When
installing the fixture hanging vertically down, you can use an open-type clamp such as a
G-clamp. When installing in any other orientation, you must use a half-coupler clamp
that completely encircles the truss or pipe circumference. To clamp the fixture to a truss:
1. Check that the rigging structure can support at least 10 times the weight of all fixtures and
equipment to be installed on it.
2. Block access under the work area.
3. Working from a stable platform, hang the fixture on the
truss and fasten the rigging clamps onto the truss.
4. Secure the fixture with a safety cable as directed below.
5. Check that the head will not collide with other fixtures or objects.
SECURING WITH A SAFETY CABLE
Secure the fixture with a safety cable (or other secondary attachment) that is approved for
the weight of the fixture so that the safety cable will hold the fixture if a primary attachment
fails. Loop the safety cable through and around a secure metal anchoring point.
WARNING! READ SAFETY INFORMATION ON
PAGE 3 BEFORE INSTALLING THE FIXTURE.
Socket outlets or external power switches used to supply the fixture with power must be
located near the fixture and easily accessible so that the fixtures can easily be disconnect -
ed from power.
Do not insert or remove power cable to apply or cut power, as this may cause arcing at the
terminals that will damage the connectors.
Do not use an external dimming system to supply power to the fixture, as this may cause
damage to the fixture that is not covered by the product warranty.
The fixture can be hard-wired to a building electrical installation if you want to install it
permanently, or a power plug (not supplied) that is suitable for the local power out- lets
can be installed on the power cable.
If you replace power plug on the power cable, install a grounding type (earthed) plug with
integral cable grip that is rated minimum 250 V, 5 A.
The fixture has an auto-ranging power supply that accepts AC mains power at 100-240 V
at 50/60 Hz. Do not apply AC mains power at any other voltage or frequency to the fixture.
For protection from electric shock, the fixture must be grounded (earthed). The
power distribution circuit must be equipped with a fuse or circuit breaker and
ground-fault (earth-fault) protection.
AC POWER
WARNING! READ SAFETY INFORMATION ON
PAGE 3 BEFORE INSTALLING THE FIXTURE.