Page
2
of
3
INSTALLATION OF LIGHT
Spike spot lights into soft ground. Adjust lamp aiming direction before installation (Fig.2)
After installation, connect spot light wire with solar panel wire (optional wire kits available for longer use) and switch
the unit to the ON (--) position located on the back of the solar panel. The light will automatically be operational when
the panel detects that it is dark enough.
II. Solar Flat Mount Light (OPTIONAL USE)
INSTALLATION OF THE SOLAR PANEL
Drill 4 holes (dia. 8mm) on any flat surface using the flat wall mount as a template to determine hole location. (Fig.3)
Attach wall mount to solar panel by using provided butterfly nut (Fig.4)
Attach the solar panel to the surface by using provided screws(Fig.5)
The solar panel is adjustable. Adjust the angle of solar panel to 45 degrees for best results. The installation location
must be located to capture the most possible sunshine during the day. IDEAL LOCATION OF THE SOLAR PANEL WILL BE
FACING SOUTH AT A 45 DEGREE ANGLE TO THE HORIZON.
INSTALLATION OF LIGHT
Drill 3 holes(dia. 8mm) on an appropriate flat
surface using lamp flat mount base as template to determine hole
location.(Fig.6)
Attach wall mount to lamp by using provided nut (Fig.7)
Attach the lamp unit to the surface by using provided screws and anchors. (Fig.8). Adjust lamp initial aiming direction
before installation.
After installation, connect Spot light wire with Solar panel wire (optional wire kits for longer use) and switch the unit on
the back of the solar panel. The light will automatically be operational when the panel detects that it’s dark enough.
III. Solar Flag Pole Light (OPTIONAL USE) – NOTE TWO SGG-POLEMT-S12 WILL BE NEEDED
Take off the adjustable arm part of LED lamp. Remove and save the machine fine threaded screw for future
use. (Fig.9)
Attach lamp to pole black PVC mount base by using coarse threaded screw provided.
Fig.4
Fig.7
Fig.3
Drill holes following to
this unit
Fig.5
Fig.6
Drill holes following to this
unit
Fig.8
