Page
2
of
2
REMOTE CONTROL Use
Dimmer and timer function.
Dimmer Options: 10%, 30%, 50%, 70%, 100%
Timer Options: 2 Hours, 4 Hours, 6 Hours, 8 Hours, 10 Hours
Press the corresponding button for desired working mode.
Selected working mode remains unchanged until new mode is selected or power switch
is turned to off position.If the light is turned OFF by remote control, lamp must be turned
ON again by remote control or by resetting the power switch to the OFF position.
Doing so returns the unit to Factory Default settings.
NOTE:
When lamp is set by remote control, light will have a flash to hint selected mode is set
successfully.
PIR Motion Sensor Use
Locate PIR lead wire from lamp body, unscrew waterproof cover.
Connect PIR wire to lamp connector.
Turn the button “OFF” on remote control (See pic) then lamp auto switches to PIR motion mode.
The brightness of PIR motion is 100% brightness.
Upon detection of movement, the PIR sensor, will automatically light and will operate continuously and remain on.
The light will remain on up to 35 seconds after motion leaves the detection zone.
OPERATION
ln the Dusk to Dawn mode (no remote control and no PIR motion), the lamp will turn on automatically at dusk and off at
dawn. The factory default setting when the ON position is selected and no Remote Control used is fixed for 4 hours at 100%
brightness then automatically switches to 50%. If the light operates without remote control, lamp keeps this working mode
all the time.
NOTES
Charge the battery for at least 24 hours before first use.
The battery only charges when the power switch located on
lamp housing is in the ON position. The ON position is demonstrated when the Power button is Popped Up.
Solar panel cannot be placed in shade and must be put placed where it can receive maximum unobstructed direct
sunlight.
BATTERY REPLACEMENT
If lamp begins to illuminate dimly or last a shorter length of time, and the hours of sunlight per day are in excess
of 8-10 hours per day, you should replace the rechargeable lithium ion battery using the following steps:
1) Remove 4 screws from the back of the light head. Carefully separate back cover from the lamp body. Set aside.
2) Disconnect battery quick connector plug. Replace with a new battery and join battery connector plug and
remount in reverse steps as done above.
3) Replace battery cover onto body housing. BEFORE securing screws into body, make sure rubber sealing gasket
is not “pinched” in sealing grove. Failure to secure correctly will allow moisture into the unit voiding warranty.
4) Be sure and recycle your old battery and do not discard in trash.
NOTE: Battery may be obtained by contacting your retailer
WARNING:
1) Do it carefully to prevent wires from being damaged.
2) Be sure that battery polarities are correct. Wrong polarity is dangerous.
3) Do not dispose of old battery. It should be recycled.
www.SolarGoesGreen.com
