Page 2 of 2
OPERATION
The lamp will light automatically after dark. The SGG-F156-3R has a unique battery circuit that will provide full
illumination on full battery charge, but will also detect when the battery output level has reached 50% and reduce the
light output to increase the hours of illumination while reducing output by 50%.This control feature will also ensure
the battery does not discharge battery to damaging level.
POWER SWITCH DESCRIPTION:
ON
--- ON at night and charging during the day
OFF
--- Completely OFF
Remote
--- Remote control can operate light’s ON/OFF
NOTES
·
Charge the battery in ON or Remote
position as noted above, for at least 2days before first use. THIS IS
IMPORTANT
·
Solar panel cannot be placed in any shade or under buildings and should be put placed where it can receive
maximum unobstructed sunlight.
BATTERY MAINTENANCE
When the lamp is not in use, place the switch in position ON or Remote and charge it 20 hours or more under the
sunlight, then switch OFF.
Please note the battery must be recharged every 3~5 months even if the light is not being used, or battery will be
damaged and will need to be replaced!
BATTERY REPLACEMENT
If lamp begins to illuminate dimly or last a shorter length of time, and the hours of sunlight per day are in
excess of 8-10 hours per day, you should replace the rechargeable lead acid battery using the following
steps:
1
）
Remove the top cover of the battery box.
2
）
Disconnect the two connectors from battery and remove the old battery.
3
）
Install the new battery and remount in reverse steps.
4) Be sure and recycle your old battery and do not discard in trash.
Please note the default operation mode of the SGG-F156-3R is factory programmed with a default
operation for the lamp for Dusk to Dawn operation. If remote control operation is desired, please move
the power selection switch to REMOTE. This will then allow operation using the remote control RF FOB.
Selecting this position will allow the lamp will to turn on automatically with darkness. In the REMOTE
switch selected position, to cycle the lamp on simply use the RF Remote Control and press the UNLOCK
button to turn on the lamp and depress the LOCK button to turn off the light. If depress the LOCK
button finally on the first night, it will not no longer allow the lamp to turn on automatically with
darkness. If depress the UNLOCK button finally on the first night, it will allow the lamp to turn on
automatically with darkness. To return the lamp to Dusk to Dawn operation, cycle the master power switch
to the OFF Position and then back to the ON position to restore the factory default Dusk to Dawn operation.
WARNING:
1) Do it carefully to prevent wires from being damaged.
2) Be sure that battery polarities are correct. Wrong polarity is dangerous.
3) Do not dispose of old battery. It should be recycled.
www.solargoesgreen.com
