![SolarGoesGreen SGG-F108-2T Скачать руководство пользователя страница 2](http://html1.mh-extra.com/html/solargoesgreen/sgg-f108-2t/sgg-f108-2t_quick-start-manual_1313850002.webp)
Page
2
of
2
OPERATION
ln the Dusk to Dawn mode (no remote control), the lamp will turn on automatically at dusk and off at dawn. The
factory default setting of SGG-F108-2T when the ON position is selected and no Remote Control used is fixed for 4
hours at 100% brightness then automatically switches to 50%. If the light operates without remote control, lamp
keeps this working mode all the time.
NOTES
Charge the battery in charging
position as noted above, for at least 2 days before first use.
Then move switch to
ON position by selecting the power switch to ON for dusk to dawn.
Solar panel cannot be placed in shade and must be put placed where it can receive maximum unobstructed direct
sunlight.
BATTERY REPLACEMENT
If lamp begins to illuminate dimly or last a shorter length of time, and the hours of sunlight per day are in
excess of 8-10 hours per day, you should replace the rechargeable lithium ion battery using the following
steps:
1) Remove 6 screws from the face of the light head. Carefully separate face from lamp body being careful
not to lose the rubber washers from each screw. Remove slowly as LEDs in face are attached to lamp
housing. Set aside.
2) Remove 8 screws from the Grey Controller/Battery Box located on the back of the solar panel. Carefully
separate the cover top from body being careful not to lose the rubber O-ring sealing the cavity. Set aside.
3) Disconnect battery quick connector plug. Replace with a new battery and join battery connector plug and
remount in reverse steps as done above.
4) Replace Controller/Battery Box top onto body housing. BEFORE securing screws into body, make sure
rubber sealing gasket is not “pinched” in sealing grove. Failure to secure correctly will allow moisture into
the unit voiding warranty.
5) Replace LED lamp face onto lamp body housing. BEFORE securing screws into body, make sure rubber
sealing washers are on each screw. Failure to secure correctly will allow moisture into the unit voiding
warranty.
6) Be sure and recycle your old battery and do not discard in trash.
NOTE: Battery may be obtained by contacting your retailer
WARNING:
1) Do it carefully to prevent wires from being damaged.
2) Be sure that battery polarities are correct. Wrong polarity is dangerous.
3) Do not dispose of old battery. It should be recycled.
UPC
850901003378
www.SolarGoesGreen.com