SOLARFOCUS Vampair, Руководство по установке

Страница: 26 / 52

6 Install electric heating element
7.4.4 Fit temperature sensor T1 for con-
denser
Fit temperature sensor T1 to the primary circuit
connection set (if using the optional electric heating
element, see
> 21 )
►
Secure the sensor 1 to the brass connection
angle 2 with fabric tape.
►
Install insulation and connect with fabric tape at
connection point.
Abb. 2-35: Temperature sensor T1
7.4.5 Heat pump pipe
–
For primary circuit connection from the underside
of the heat pump, we recommend laying in the
ground with the SOLARFOCUS heat pump pipe.
–
2 dimensions available:
Dimensions and design external diameter 32
The dimensions are important for placement in the
concrete foundation
> Abb. 2-50, > 40
i
Connect both pipes (for bus cable and power
cable) once the electrical installation is com-
plete
> 29
Dimensions and design external diameter 40
The dimensions are important for placement in the
concrete foundation
> Abb. 2-50, > 40
i
Connect both pipes (for bus cable and power
cable) once the electrical installation is com-
plete
> 29
26 Installation manual vampair