SOLARFOCUS pellettop 35/45, Руководство по эксплуатации

Страница: 37 / 44

17 Troubleshooting
17 Troubleshooting
Faults that occur are displayed in an information win-
dow in the control and each message is save in the
message log > 14 .
Fig. 2-58: Note window Fault
Handling of messages
– Button 1 : Close window, change to main screen.
The fault message remains active, i.e. the burner
may not start depending on the type of message.
–
Button 2 : Switch to the message log
– Button 3 : Acknowledge the message.
An acknowledgement is only possible if the cause
of the fault has been rectified; the burner may then
restart after a heating request is received.
An alarm message is visible at the top edge of the
main screen until it is acknowledged
1 . Press to ack-
nowledge the message (message window opens)
Fig. 2-59
Alarm symbol
This symbol indicates an alarm message: The
boiler is no longer ready for operation if such a mes-
sage occurs.
Note symbol:
This symbol indicates an alarm message: The
boiler is still ready for operation.
Possible messages:
In accordance with the prevailing message, it is deter-
mined who is supposed to take the required action
(system operator
SO or qualified personnel QP ).
No. Message AB FP
1 Error in internal memory x
2 Feeder sensor short circuit x
3 Ignition not possible Check the container
fill level sensor
x
4 Extraction room may be empty x
5 Flue gas temperature too low x
Flue gas sensor interruption x
7 Flue gas sensor shows wrong measured
value
x
8 Feeder sensor interruption x
9 Flue gas sensor short circuit x
10 Factory settings loaded x
11 ID fan error x
12 ID fan test running x
13 The functionality of the induced draught
fan is no longer intact
x
14 Maximum suction time reached x
15 Feeder sensor shows the wrong measured
value
x
16 Lambda sensor faulty x
17 Boiler sensor defective x
18 Boiler temperature is too high x
19 Extraction auger is blocked x x
20 First ignition attempt failed x
21 Triac output feeder defective x
22 Triac output room extraction defective x
23 DFSH module communication error x
24 Overtemperature reset or safety chain has
been triggered
x
25 Power failure detected x
26 Mains fuse defective x
27 Triac fuse defective x
30 Feeder is blocked x
31 Heat exchangers are blocked x
32 Heat exchangers are blocked x
33 Line interruption to feeder motor x
35 CAN bus interruption x
36 Fuse at fresh water module defective x
37 Fuse on module defective x
38 Commissioning settings loaded x
39 Solar setting Max. tank temperature bot-
tom can trip safety temperature limiter
x x
40 Ignition not possible x x
41 Fuse F1 or F8 defective x
Operation manual pellettop 37