SolarEdge Cellular Plug-In, Руководство по установке

Страница: 15 / 23

Installing the Plug-In in the Inverter
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the inverter
cover is removed.
To Install the Plug-in in the inverter:
1. Remove the inverter cover as described in its manual.
2. Locate the Plug-in in its place on the communication board, as shown in the figure
below. Follow these guidelines:
Plug in the Plug-in making sure that all pins are correctly positioned in the
Plug-in connector, and no pins are left out of the connector.
Make sure that the Plug-in is secured firmly in place.
3. Route the antenna cable via the safety switch, securing the cable on the
communications board using the cable tie supplied with the plug-in, as shown in
the figure below.
4. Connect the antenna cable to the cellular Plug-in and tighten manually.
5. Turn the AC ON.
6. Check that all the cellular Plug-in LEDs are lit. If not, refer to "Viewing Error
Messages and Troubleshooting" on page 16
Cellular Plug-in Installation Guide
14 Installing the Plug-In in the Inverter