WATTrouter M - user manual
How to fit and setup the device
Page 7 from 79
SAFETY WARNING
When you receive your package, inspect the packaging unit for damages. After opening
your package, inspect the regulator and the current sensing module for damages. Do not fit
the regulator or the current sensing module if you see signs of mechanical damages!
Always have the regulator and the current sensing module fitted by a person with the
necessary electrical qualification. It is necessary that you read this manual thoroughly and
observe all safety warnings and requirements specified herein.
The regulator and the current sensing module must be fitted in a dry room without
excessive dust level. The room must be protected from direct sunlight and the ambient
temperature must be maintained within the range mentioned in chapter Technical
specifications. Do not place the regulator or other electronic components of this system
near flammable objects!
When power SSRs are connected to SSR outputs or built-in triacs are used, it is absolutely
necessary to fit these into a distribution box equipped with adequate heat dissipation
system (with ventilation grid or vents)!
Make sure that unauthorized persons, mainly children, cannot access the location where
the controller is fitted. There is a serious risk of electric shock!
Only connect outputs of the controller to electrical loads which have been designed for this
operation mode and for which the manufacturer does not explicitly prohibit connection via
switching element!
The manufacturer is not liable for any damages occurred due to improper fitting or
operation of the device! The owner is fully responsible for operation of the entire system.
