1- Raise take-up lever to its highest position by turning hand wheel
toward you. Raise presser foot.
2- Place spool on spool pin as shown, with thread coming from the back
of the spool.
3- Draw thread into thread guide using both hands.
4- Draw thread down into the tension area and around the check spring
holder.
5- Fimly draw thread up and through take-up lever from right to left.
6- Then draw thread down and slip it into the lower thread guide.
7- Draw thread down and slip it into needle bar thread guide.
Thread needle eye from front to back.
-NOTE: You may want to cut the end of thread with sharp scissors for
easier needle threading.
Drawing up bobbin case:
1-Raise the presser foot and hold the needle thread lightly with you left
hand.
2-Turn the hand wheel slowly towards you with your right hand until the
needle goes down and continue turning the hand wheel until the take-up
lever is at its highest position. Lightly draw up the needle thread forming
a loop of the bobbin thread.
3-Pull 15cm (6 inches) of both thread back and under the presser foot.
:
n
o
i
s
n
e
t
d
a
e
r
h
t
e
l
d
e
e
n
g
n
i
c
n
a
l
a
B
-The needletop thread and the bobbin thread should interlock in the
center of two layers of fabric in straight seams.
-Set the desired number of the thread tension dial at setting mark.
-Tighten the needle thread tension by moving the dial to a higher
number.
-Loosen the needle thread tension by moving the dial to a lower num-
ber.
-NOTE: In order to obtain better zigzag stitches, the upper thread
tension should be slightly weaker than the bobbin thread tension. That
means, the upper thread should appear slightly on the reverse side of
the fabric, but the bobbin thread cannot appear on the top side of the
fabric.
Reverse stitch button:
-As long as you are pressing down this lever while sewing, the machine
will continue to feed the fabric backwards.
Seam guide line
-The numbers on the needle plate indicate the distance between the
center needle position and the line.
-The numbers in the front indicate in Millimeters.
-The numbers in the back indicate in inches.
Dropping the feed dogs:
