5
rev.1011 MKTG-IM-TP
-34
-002
Installation and Owner’s Manual | TP Series Solar LED Lighting System
TABLE 1
LIST OF FASTENERS
2.2 Unpacking and Inspection
The Sol TP Series lighting system is shipped as a complete kit. Prior to assembly,
remove the entire contents of the kit from the packaging and check the contents of the kit
against the Packing list you received in the ”OPEN FIRST” envelope.
The fasteners that are provided with the parts and components and the torque to which
each type of fastener should be tightened is shown Table 1.
Refer to packing list for complete parts and call Sol Customer Service at
+1.772.286.9461 if any components or hardware are missing,
* Recommended Torque
2.3 PV Panel Assembly and Adaptor Mounting
1.
Lay PV panels side by side on cardboard packaging to protect surface of PV
panels.
2.
Place TP assembly in center of panels. Place top and bottom “Z” struts lining
up screw holes with TP assembly. Secure TP assembly with 4x 5/16-11 x 3”
screws.
3.
Align slots in Z-strut with pre-drilled PV module holes and secure “Z” struts to PV
panels using 16x 5/16-11 x 3/4” security screws. (Figure 3).
Fastener
Qty.
Torque*
Qty. Torque*
5/16-18 x 3” screw (2 washers/lock washer/nut)
7 ‘A’
11 ft. lbs 5/8-11 x 10” bolt (2 washers/lock
washer/ nut)
2 ‘L’ 93 ft. lbs
5/16-11 x 1” screw (2 washers/lock washer/nut)
18 ‘A’ 11 ft. lbs
5/8-11 x 6” bolts (2 washers/lock washer/ nut)
3 ‘A’
93 ft. lbs 3/4-10 x 12” bolt (2 washers/lock
washer/ nut)
2 ‘B’ 93 ft. lbs
3/8-16 x 1/2” cup point screw
3 ‘A’
20 ft. lbs 1/4–20 x 1/2” hex head bolt
4 ‘B’ 6.3 ft. lbs
A - Part of TP fastener kit
B- Part of Battery fastener kit
L - Loose part
Extra 5/16 fasteners included
Orientation of PV J-boxes should be
at top end of tilted panel
FIGURE 3
MOUNTING PV PANELS TO TP ASSEMBLY
16x
4x
