Assemble the ghost: - - - - - 6
1
2
3
4
5
A
ASSEMBLY INSTRUCTIONS
1
2
6
4
5
3
Push the eyes and lantern
into the ghost.
Solder point
And now the:
B
Trim one end of the resistors with wire cutters:
Trim the
post of the LEDs with side cutters:
SHORT
2 x
1 x
approx. 8 mm
approx. 8 mm
approx. 8 mm
2.2 kOhm
1 kOhm
short
= „-“
long = „+“
long
= „+“
before
after
NOTE:
The post of the orange LED
is red! Do not reverse.
brown-black-black-brown-black
red-red-black-brown-black
C
Solder LEDs and resistors together.
(pre-tin the indiviual wires)
ATTENTION! Pay attention to the correct resistance!
The ring colours indicate the resistance.
2,2 kOhm
2.2 kOhm for red
1 kOhm
1 kOhm for orange
LED,
(lantern LED)
orange LED
2 x LED, red LED
(eye LED)
Solder point
Solder point
brown-black-black-brown-black
red-red-black-brown-black
Result:
HOT!!
D
E
F
Place the 3 positive contacts for the LED on top of
each other as shown and solder:
Solder point
Trim the excess wire for
the positive contacts
and solder on the last
resistor as shown.
G
Solder point
Trim
Now trim the cables for the battery clip to 8 cm
(use template), strip the insulation,
pre-tin and solder as shown:
Solder
point
Checked everything and found no
short-circuit?
Then you can connect the battery.
All LEDs should now light up and
flicker like a candle
Changes and errors reserved -
July
2018
/
Christian
Repky
©
I
H
To switch off the LEDs simply
disconnect the battery clip.
ATTENTION!
The wires soldered to the resistors
must not touch the wires for the
positive contacts. This would cause
a short-circuit, damaging the battery!
brown-black-black-brown-black
((Use template from page 1)
Push the eye LEDs into the wooden piece as shown,
and
then solder.
bend the feet with resistors
Wood
Wood
wrong!
right!
Note the
resistor
position!
LED
LED
