Sokkia GSR2700 IS, Инструкции по эксплуатации, Страница: 60 / 87

GSR2700 IS Operations Manual 49
Collecting Data Chapter 6
POWERUP configuration will run until the controller takes
control of the receiver.
Commands issued to the receiver through the controller will
supersede the POWERUP configuration resident on the receiver
(see Section 6.3.1,
About the POWERUP configuration , page 49).
The receiver begins using the POWERUP configuration again
when you turn the receiver off and back on again.
Use the options in the SDR+ software to determine whether data
is stored on the receiver or on the controller.
6.2.2 Logging to the internal memory
Turn the receiver on by pressing the power button (see Section
3.1,
Power Button , page 20). Once the GSR2700 IS has acquired
GPS satellites, it will automatically start collecting data based on
the POWERUP definitions (see Section 6.3.1,
About the
POWERUP configuration , page 49).
NOTE For information about downloading data from internal memory,
see Section 4.1,
Setting Up at the Office , page 34.
6.3 Defining Data to be Collected
You can define what type of information should be collected
during a data collection session by using tools available in the
Sokkia
Planning software to transfer a POWERUP configuration
to the receiver.
NOTE The GSR2700 IS does not support the use of schedules.
6.3.1 About the POWERUP configuration
A receiver’s POWERUP configuration is a group or set of data
that tells the receiver what type of information should be stored
during a data collection session.