Figure 8: Set of WB169-430 module components with rod antenna
In the figure
there is displayed the detail of WB169-430 module printed circuit board with configuration connector
marked by red colour, antenna connector marked by blue colour and battery switch marked by green colour.
Appearance of the module PCB could slightly vary in dependence on the module modification.
Figure 9: Detail of WB169-430 module PCB
The case of WB169-430 module consists of two parts:
•
module base with the printed circuit board attached. It is the part, where the antenna cable bushing is placed;
•
box cap that covers the printed circuit board, with mounts for attaching of the module to the wall or other
construction element
When mounting the device follow these instructions:
•
attach the module to a suitable firm object (wall, pipe) by two screws or by a clamping tape. There are
mounts by the box sides for the attachment. The recommended position of the mounted module is in the way
that the base is down, cable bushings are facing to the floor;
•
unscrew the screws on the sides of the module base (right beside the cable bushings), loosen the cap of the
module and slide the base out of the cap (*);
•
connect the local antenna (stick or rod type) or an antenna cable from a remote antenna into the antenna
connector (coaxial connector on the printed circuit board beside the input clamps). Pull the antenna or the
antenna cable through the cable bushing that is just right opposite to the antenna connector;
•
switch-on battery by switching of micro-switch (
”
jumper”) placed on the PCB into the
”
ON“ position. Some
modifications of the module could be equipped with a pair of simple shortening pins, that should be short-
circuited by shortening connector;
WB169-430
23
