Chapter 9 - Declaration of conformity
Version EN-092019-1.21
65
9
Declaration of conformity
This device is compliant with EC directive 2014/30/EG, "Electromagnetic Compatibility" (EMC directive)
and meets the following requirements:
EN 55011
Industrial, scientific and medical (ISM) devices - radio disturbance -
limits and methods of measurement
EN 55032
Electromagnetic compatibility of multimedia equipment (MME) and interference
emission
EN 61000-6-4
Electromagnetic compatibility (EMC); Part 6-4: generic standard –
emission for industrial environments
EN 61000-6-2
Electromagnetic compatibility (EMC); Part 6-2: generic standard -
immunity for industrial environments
Note
To fulfill the EMC requirements, the other components of your installation (DC adapter,
Industrial Ethernet devices, etc.) also have to meet the EMC requirements. A shielded cable
must be used. In addition, the cable shield must be grounded properly.
CAUTION
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures!
CE
A Declaration of Conformity in compliance with the above standards has been made and can
be requested from Softing Industrial Automation GmbH.
RHOS
This product is RHOS compliant.
FCC
This equipment has been tested and found to comply with the limits for a Class A digital
device, under part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications.
VINCI
This Class A product conforms to the regulations of Voluntary Control Council for
Interference (VINCI) by Information Technology Equipment.
WEE
Electrical and electronic equipment must be disposed of separately from normal waste at the
end of its operational lifetime. Packaging material and worn components shall be disposed of
according to the regulations applicable in the country of installation.
