Chapter 2 - About the EtherNet/IP Gateways
Version EN-062020-1.00
7
2
About the EtherNet/IP Gateways
The Softing EtherNet/IP Gateway offers robust data mapping between an EtherNet/IP scanner and a
PROFIBUS master for easy connection of PROFIBUS network slave devices to an EtherNet/IP control
system.
The
epGate PA
is available as a 2-channel model and a 4-channel model. Both models integrate
PROFIBUS PA (
P
rocess
A
utomation) networks in EtherNet/IP systems at a fixed speed of 31.25 kbit/s.
The 2-channel model supports up to 32 PROFIBUS PA devices and the 4-channel model up to 64
PROFIBUS PA devices. This gateway is typically used in areas of process automation with explosive
atmosphere.
The
epGate PB
integrates PROFIBUS PA (
P
rocess
A
utomation) and PROFIBUS DP (
D
ecentralised
P
eripherals) networks in EtherNet/IP systems at speeds of up to 12Mbit/s. It maps two PROFIBUS PA
and one PROFIBUS DP network segments supporting up to 32 PROFIBUS PA and 32 PROFIBUS DP
devices. This gateway is typically used with a centralized controller in factory automation.
The
epGate DP
integrates one PROFIBUS DP (
D
ecentralised
P
eripherals) network with up to 32
PROFIBUS DP devices in EtherNet/IP systems at speeds of up to 12Mbit/s.
All three gateways support industry-standard device configuration, parameterization and condition-
monitoring tools.
Engineering systems and asset management systems
The EtherNet/IP Gateway can be managed with the following tools:
EtherNet/IP engineering system (e.g.
Rockwell Studio 5000, Emerson DeltaV
)
FDT frame application (e.g. PACTware)
Siemens SIMATIC PDM (Process Device Manager)
2.1
Intended use
This series of gateways has been designed to integrate PROFIBUS network slaves in EtherNet/IP networks.
Any other use is not intended. Follow the instructions in this document on how to configure and operate
the gateways.
CAUTION
Do not use this device in hazardous areas! See Section
for permissible
ambient conditions.
2.2
Specifications
Power supply
18 VDC...32 VDC; SELV/PELV supply mandatory, typical input current 200 mA
(max. 1 A, considering rush-in current at switch-on).
Ethernet
IEEE 802.3 100BASE-TX/10BASE-T
Minimum ambient
operating temperature
for the maximum ambient temperature
depending on the mounting position)
Storage temperature
-40 °C...+85 °C
Relative humidity
10 %...95 % (non-condensing)
Altitude
must not exceed 2000 m
Location
indoor use only; no direct sunlight
7
13
