!
!
3.3 Coupling on and uncoupling from the excavator
3.3.1. Coupling
1) Place the hammer horizontally with its axe parallel to the excavator boom on the ground in
a stable position.
2) Remove the clamps holding the bucket and take the bucket away.
- Stop the hydraulic system of the excavator
.
- Take the caps out of the system and in case they have no taps, collect the hydraulic oil in a
container, then fix the hoses connecting the hammer to the system (see scheme “Hammer
hoses connection” par. 3.2) and open the oil taps if present.
- Stock away the caps of the flexible hoses, which will be used again during the next
uncoupling of the hammer.
3.3.2. Uncoupling
- Place the hammer horizontally on the ground in a safe area.
- Stall the hydraulic system of the excavator.
- Close the hoses' flow if possible.
- Disconnect the hoses and close up the ends of the flexible hoses in order to prevent oil
leaking and dirt intake.
- Remove the connecting rod pin.
- Remove the boom pin.
- After unblocking the hydraulic system, take the excavator boom out of the adapting plate.
Insert the boom end in the middle of the
handles of the adapting plate.
- Line up the hole of the excavator boom
with the equivalent one on the adapting
plate, insert the first pin and fix its
clamps.
- Then line up the hole of the connecting
rod with the second hole on the adapting
plate, insert the second pin and fix well
its clamp.
TRANSPORT AND INSTALLATION
13
Page
of 48
3
Nederland B.V.
Содержание MDO 1600 TS
