Installation and Commissioning Guide DIRIS DigiBOX A
Ref: dcg_A402019us.rev1 Page 6/15
SOCOMEC PM
Installation and Commissioning Guide DIRIS DigiBOX A
3. Install Mounting Feet to the Back of the Enclosure
1. The DIRIS DigiBOX A is shipped with the mounting feet in the bag.
Figure 2: Mounting feet and hardware provided with the DIRIS DigiBOX A.
2. Turn the enclosure so the back side is visible. Then place the mounting feet over the octagon pieces (you can
place the mounting feet horizontally, diagonally, or vertically) and fasten them with the ¼ inch -20 x 0.25 inch
SS, countersunk Phillips drive screws (torque limit is 30 in. lbs.).
Figure 3: Three ways to put the mounting feet on the enclosure (vertical, horizontal, and diagonal).
3. The enclosure is now ready to be mounted vertically (i.e. on a wall) or horizontally (i.e. on a table top).
4. To mount the unit, use #10-32 ¾ inch panhead screws and screw directly in the center of the cross on the
mounting feet.
Figure 4: Red dot indicates where to screw when mounting on surface.
