2
Assembly
Installing the Eye Bolt
Washing and Care Instructions
Important Reminders:
Your Seaside Hammock Chair comes fully assembled and ready to hang. Inside the carry case,
you’ll find the hardware pack wrapped inside of the cupholder and the footrest.
Note: The hardware pack contains 1 eye bolt, 1 S-hook, and 1 chain.
Locate the ceiling beam/joist by using a stud finder or tapping
and verifying with a small nail. Be sure to locate the exact
center of the ceiling joist for the most secure installation.
Using a 3/16” (3mm) wood drill bit, drill a starter hole
(approx. 4” or 10 cm deep) perpendicular to the ceiling.
Screw in the supplied eye bolt until all threads have
disappeared into the joist. Do not loosen or adjust once in
place.
Caution: swinging or spinning could loosen the
eye bolt from the ceiling joist and compromise the
sturdiness.
We highly recommend hanging the Savannah
Classic
no more than 18” above the ground
and not exceeding
a maximum weight recommendation of 300 pounds.
Your Seaside Hammock Chair will last longer depending on its use, where it is installed, and the
care it is given. It will last longer if you keep it dry by either covering it (yes, we sell those!) or
storing it indoors when not in use. We recommend using a fabric protector such as Scotchgard
on the pad and ropes to resist stains. To wash, scrub gently with a soft brush and a mixture of
water and a mild laundry detergent. You can spot-treat stains using Resolve, Shout, or other
laundry stain removers on the fabric parts of the chair.
Warning: Not suitable for washing
machines, tumble dryers, or chemical bleaches.
The Seaside Hammock Chair is NOT a swing. We highly recommend using only a gentle to
and fro motion. Swinging or spinning could loosen the eye bolt from the ceiling joist and
compromise the sturdiness.
Check the eye bolt from time to time to make sure
it’s holding fast.
