Connections Properties — INITIATOR MODE
When to connect
•
Connect automatically
: Select for the CSA to connect automatically.
Note: If you check
Connect automatically
, the CSA will need to receive
a software command to initiate a connection.
•
Only when DTR is asserted by the local host
: Check ONLY IF
you know that the local host sends DTR (Data Terminal Ready)
signals. If you are not sure, uncheck the box.
Important!
If you check
Only when DTR is asserted by local host
, the CSA will only
initiate connections after receiving DTR signals from the local host. If you
are not sure whether your local host sends DTR signals, or if you have
trouble connecting, UNCHECK this box.
If you enable
Connect automatically
but disable
Only when DTR is asserted
by local host
, the CSA will always automatically try to connect to the
target device. If the target device is within range, you may have trouble
using the Socket CSA Configuration Utility, because the CSA has already
connected to the target device. If you are experiencing these problems,
move the target device about 10-30 meters away (outside the Bluetooth
range), in order to break the connection.
28
