ST-660 Mode Setting
I.
SPECIAL FEATURES:
1. One set stand alone design.
2. After installation of proximity reader and connected to power source,
the red power indicator on the front panel will brights up. After two
seconds, there will be a “beep” sound . The display will show as
follows:
X means door identification mode. The
mode default set at 2 which means door
open by proximity card.
3. Provide 4 types door opening modes:
(1) press 4 digits door opening password, identification code is 1.
(2) Proximity card door access, identification code is 2.
(3) Proximity card plus press 4 digits door opening password ( 8
sets 4-digits door opening passwords), identification code is 3.
(4) Proximity card or press 4 digits door opening password,
identification code is 4.
4. When entering into the system setting mode, the 4-digits system
password should be used in order to conduct functional selections
of system setting modes. System code is being set at 5678 on
production. In order to enter into the system to set up mode, press
# first then press password and press # again after completion.
The system setting mode is now being entered.
(such as pressing # 5 6 7 8 # ).
5. All proximity card or proximity key tag before being use in this
reader must go through the activities of registrations.
6. Proximity card or key tag from our company has a 8-digits numeric
code.
7. Provide 8 sets of door opening passwords.
8. Maximum storage capacity is 10,000 cards.
9. Data memory feature for in case of power failure.
10. Adopts LCD backlight display panel which will enable user to has a
better vision and operates easier.
II.
FRONT PANEL AND TYPES OF PROXIMITY CARD:
FRONT PANEL
1. Indicator light :
(1) Power light (
red
) : power indicator light.
(2) O.K light (
green
) : door open indicator light.
(3) Deny light (
yellow
) : operation error or card has not
been registered yet.
(4) Status light (
yellow
) : enter into setting mode indicator light.
<<
S T – 6 6 0
>>
X
P. 1
