33
Attention
• Always ensure the drain hose is free of obstructions of any kind, since this will have an adverse affect
on the smooth running of your machine.
• Only install your machine in a room protected from frost.
• The company excepts no responsibility for improper use, or maintenance work carried out by
unauthorised service personnel resulting in water damage.
Connection and installation
Attention:
The washing machine must be properly installed and connected.
The washing machine was tested before leaving the factory. To make sure that any traces of water
used in the test are removed, wash for the
fi
rst time without introducing any dirty linen.
• do not put any dirty linen into the machine
• open the water cock
• place 1/2 measuring cup of detergent in the chamber foreseen for the main detergent
• start the „easy-care /
fi
ne wash” programme at 60°C and let it run its course
The washing machine is now clean and ready for operation.
Prior to the
fi
rst wash
Setting up and starting
• Ensure the unit is on an even,
fi
rm surface.
• All four screw-mounting feet must stand
fi
rmly on the
fl
oor.
• To set up the machine, adjust one or more of the screw-mounting feet by
loosening the counter-nuts.
• After adjusting the screw-adjustment feet, tighten the relative lock nuts again in
the direction of the arrows (with a SW 17 spanner).
• Turn on the tap and check the run off hose.
