SnowWolf AlphaBlower 36-106-P, Руководство по эксплуатации и техническому обслуживанию

Страница: 42 / 76

40
AlphaBlower Operation and Maintenance Manual
Maintenance
AlphaBlower
Disassembly
AVOID SERIOUS INJURY OR DEATH
Securely block up the snow blower before
working underneath.
1. Provide support beneath the augers and using
wooden blocks.
Figure 5
2. Remove flanged bearings (Item 1) and
retaining rings (Item 2) [Figure 5] from both
sides of the blower housing.
3. Loosen the set screws on the flange on the
outer part of the augers and pull off.
4. Unbolt the inside edge of the auger mounting it
to the gearbox (Item 3).
5. Then push the rest of the augers out to the side
so that they come loose from the mounting
flange on the gearbox and lift them out.
Figure 6
6. Support the gearbox (Item 3) [Figure 6] using
a jack or similar.
7. Ensure that the gearbox is properly secured; it
weighs approximately 250 lbs without oil.
8. Loosen the bolts (Item 4) [Figure 6] for the
gearbox and lower it slightly.
Figure 7
9. Disassemble the bearing (Item 5) on the
impeller axle and pull the impeller axle (Item 6)
with impeller (Item 7) and the cutout clutch
(Item 8)
[Figure 7] out.
1
2
3
4
3
4
5
6
8
7