SnowWolf AlphaBlower 36-106-P, Руководство по эксплуатации и техническому обслуживанию

Страница: 24 / 76

22
AlphaBlower Operation and Maintenance Manual
Operation
PTO Shaft Angle
Figure 2
NOTE: [Figure 2] shows the relation between
the height (H) of the tractor’s PTO and the
angle of the PTO shaft. Use the diagram as
follows:
Use the diagram as follows:
1. Measure the height H from ground level up to
the center of the tractor’s PTO stub shaft (1).
2. Measure the horizontal distance A or B from
the end of the tractor’s PTO stub shaft to the
tractor drawbar ball.
3. Mark the position of the PTO stub shaft end (1)
in the diagram for the figures. Grid pattern is
2x2in.
4. Mark the link (2) at a distance of 2.3in from the
end of the PTO stub shaft.
5. Read the angle using the dashed angle lines.
Angles greater than 20° result in abnormally
high wear and reduced service life of PTO
shafts.
PTO SHAFT ANGLE - REVERSING AND FRONT MOUNT
1
3
5°
10°
2
15°
20°
H
2
1
H
A
11.75”
2.33”
23.5”
2”
2”
27.5”
6.33”
15.75”