SnowWolf AlphaBlower 33-100-H, Руководство по эксплуатации и техническому обслуживанию

Страница: 50 / 98

48
AlphaBlower Operation and Maintenance Manual
Maintenance
AlphaBlower
Disassembly
AVOID SERIOUS INJURY OR DEATH
Securely block up the snow blower before
working underneath.
1. Provide support beneath the augers and using
wooden blocks.
Figure 7
2. Remove flanged bearings (Item 1) and
retaining rings (Item 2) [Figure 7] from both
sides of the blower housing.
3. Loosen the screws on the flange on the outer
part of the augers and pull off.
4. Then push the rest of the augers out to the side
so that they come loose from the spline pins on
the gearbox and lift them out.
5. Ensure that the inscriptions on the cut out
clutches are readable. If necessary, relabel.
Figure 8
6. Support the gearbox (Item 3) [Figure 8] using
a jack or similar.
7. Ensure that the gearbox is properly secured; it
weighs approximately 220 lbs without oil.
8. Loosen the fixing screws (Item 4) [Figure 8] for
the gearbox and lower it slightly
9. Turn the gearbox 180 degrees and pull it loose
from the spline pin on the claw coupling (Item
5)
[Figure 8] .
Figure 9
10. Disassemble the locking ring (Item 6) by the
bearing (Item 7) on the impeller axle and pull
the impeller axle (Item 8) with the claw coupling
and impeller (Item 9)
[Figure 9] out.
1
2
3
4
5
6
7
9
8