SnowWolf AlphaBlower 33-100-H, Руководство по эксплуатации и техническому обслуживанию

Страница: 47 / 98

45 AlphaBlower Operation and Maintenance Manual
Maintenance
Auger Axle Couplings
Check the couplings between the gearbox and the
auger axle for wear. If there is significant wear, the
bushings in the coupling must be replaced. Check
that the cup springs are not damaged. Replace if
necessary. Cup springs must be installed in pairs
with the curved side facing outwards. Please be
aware that the two nuts must not be screwed all
the way in. This will cause the cup springs to be
pushed all the way together preventing movement
in the coupling.
Cutout Clutches
The augers are secured using one cut out clutch
on each axle. The PTO shaft is secured by shear
bolts.
Important! The cut out clutches on the left
and right auger have opposite direction of
rotation. They are marked with “R” and “L”.
When disassembling the augers, it is
important to ensure that the inscriptions
are readable, so that the correct re-
assembly can be done. If necessary, relabel.
NOTE: For tractors with more than 200 HP a
heavy duty PTO shaft with cut out
clutch is supplied.
Gearbox Adjusting Screws
The adjusting screws for the gearbox must be
tightened with a torque of 184 ft lbs and secured
using locking washers. Ensure that the locking
washer is in place and in good condition. Beneath
the head of each fixing screw there is a friction
washer to maintain the initial load on the bolt. The
friction washer must be installed with the curved
side facing upwards.
Hydraulic Hoses
Check that there is no damage to hydraulic hoses.
Replace any damaged hoses. Also check for any
leakages in hose connections and couplings.
Leaking fluids under pressure can enter the
skin and cause serious injury or death.
Immediate medical attention is required.
Wear goggles. Use cardboard to check for
leaks.