SnowWolf AlphaBlower 33-100-H, Руководство по эксплуатации и техническому обслуживанию

Страница: 33 / 98

31 AlphaBlower Operation and Maintenance Manual
Operation
Hydraulic Couplers
• Thoroughly clean the quick couplers
before making connections. Dirt can
quickly damage the hydraulic system.
AVOID BURNS
Hydraulic fluid, fluid tubes, fittings and
quick couplers can get hot when
running the machine and snow blower.
Be careful when connecting and
disconnecting quick couplers.
Connecting Hydraulic Couplers:
Remove any dirt or debris from the surface of both
the male and female couplers, and from the
outside diameter of the male coupler. Visually
check the couplers for corroding, cracking,
damage, or excessive wear. If any of these
conditions exist, replace the coupler(s).
NOTE: Do NOT hammer on or heat up couplers
to connect or disconnect. Doing so will
damage couplers resulting in leaks.
Install the snow blower male coupler into the
female coupler. Pull on the coupler connection to
verify that the male and female couplers are
securely fastened.
Install the snow blower female coupler onto the
male coupler. Pull on the coupler connection to
verify that the male and female couplers are
securely fastened.
Checking AlphaBlower Operation
NOTE:
After installing the snow blower, test all
functions before operating the snow
blower in the work area.
AVOID INJURY OR DEATH
•
Never start the machine from outside the
cab.
•
Never operate the snow blower if any
safety device is damaged, disconnected
or missing.
•
Never exit the machine with the engine
running.
It is the operator’s responsibility to know
which machine control operates each
function of the snow blower prior to
operating the snow blower in the work area.