5
2
Preparation
This product is intended for indoor use.
*
Select a suitable work area.
*
Work area should be relatively free from drafts and vibrations.
*
Work surface should be level and rigid.
*
Do not locate near magnetic material or equipment/instruments which use magnets
in their design.
*
Avoid area which have variations in room temperatures or have excessive room
temperatures. Room temperatures above 40 or below 0 could affect instrument
operation and accuracy.
Specifications
Model BS-Series
Display
LCD, height 25mm
Pan size
320 x 430 mm ( W x L )
Power Supply
9V/500mA, AC adapter
Built in 6V Rechargeable-battery.
Battery operating limited at 5.5V and display will show
. In this time the instrument should be charged.
Ambien Temperature
0~40 85 RH
Programme
Press and hold any key while powering
ON
. The display will shows
Press key goes to
programme sequence
.
Press key for
parameter selecting
and
Press key for
setting and goes to next step
. The programme sequence as follows:
F
F
B. Auto power off
C. Backlit
None
5 minutes after
10 minutes after
20 minutes after
30 minutes after
Auto lighting while loading
Active
None
A. Auto zero
None
ATZ 1d
ATZ 2d
Calibration
The system goes to
Calibration mode
.
4.
Press key goes to SPAN mode.
6.
Put on the
calibrating weight in kg
.
( Span value to be 50000 ~ 150000 at full capacity )
7.
Press key to cycle through a list of permissible weights.
When the weight on the scale is displayed, press key
1. Please have the jumper Jp3 switch OFF
before you start to calibrate weight.
8.
After finish the weight calibration, make the Jp3 switch ON.
Now you are ready to weigh.
( Offset value to be displayed around 5000 ~ 50000 )
5.
Press key to make display to zero.
the weight calibrating to be done.
2.
Press and hold any key while powering
ON
.
3.
Press key goes to CAPACITY mode.
Press key to select Maxium Capacity.
T
T
0
T
T
F
T
Shown on the dislpay:
Shown on the dislpay:
Installation
Remove instrument and accessories from the carton.
Save packing material for transportation purposes.
*
If using the AC adapter, insert power cord into the receptacle located on the rear
left side. Firmly push in the plug.
*
Allow the instrument to warm up for 30 minutes prior to use.
Your instrument features a numeric display that continuously shows your weighing
results.
