SNOWJOE SUNJOE TJ600E-RM, Руководство оператора

Страница: 10 / 16

9
Operation
Intended Use
The TJ600E electric cultivator is designated for small
gardens and flower beds, this electric cultivator
effectively loosens and turns over new soil. It may also be
used to mix coarse soil with fertilizer, peat, and compost. This
product may not be used to till extremely dry or wet soil.
The use of this product in rain or wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction
manual before first use and to observe all the instructions
contained within this manual.
This product is intended for private domestic use only. It is not
intended for any commercial trade use. It must not be used for
any purposes other than those described.
Connecting to Power Supply
NOTE: For safety reasons, this product is equipped with a short
power cord. Do not connect the electric cultivator directly
to the power supply using this power cord. A proper extension
cord is required for operation. Observe the technical requirements
for this product when purchasing an extension cord.
m
WARNING!
For your safety, it is required that the
plug attached to this electric cultivator be connected
to an approved extension cord. The extension cord must be
suitable for outdoor use, with all sockets protected against
water intrusion. Ensure the extension cord is of the proper size
and type for your product (≥ 1.5 mm²). Always use a residual-
current device (RCD), or residual-current circuit breaker
(RCCB) protected power supply.
1. Connect the electric cultivator to a working 120 V
outlet using a heavy-duty outdoor extension power cord,
such as the Snow Joe
®
+ Sun Joe
®
Power Joe SJTW-A
14-gauge 50-foot extension cord with lighted end (Model
PJEXT50-B). Visit snowjoe.com to order online or call
1-866-SNOWJOE (1-866-766-9563) to order by phone.
2. Make a loop in the extension cord and push it up through the
hole in the handle and around the cord restraint hook (Fig. 8),
then connect the extension cord to the appliance cord.
Powering ON + OFF
m
WARNING!
Rotating blades may cause serious injury.
The blades will continue to turn for a few seconds after the
tool has been switched OFF. Do not touch the rotating blades.
Contact with hot components (i.e. motor housing, gear box,
etc.) on the machine may cause burns. Allow the machine to
cool before handling.
1. To turn the tool ON, push and hold the safety lock button
with your thumb and then squeeze the trigger switch with
your fingers. Once the tool is running, release the safety
lock button (Fig. 9).
2. To switch OFF, release the trigger switch (Fig. 9).
Operating Tips
• Before each use, check the product, its power cord and
plug, and any other accessories for damage. Do not use the
product if it is damaged or shows wear.
• Double check that the accessories and attachments are
properly fi tted.
• Always hold the product by its handles. Keep the handles
dry to ensure a secure grip.
• Ensure that the air vents are always unobstructed and clear.
Clean them if necessary with a soft brush. Blocked air vents
may lead to overheating and damage the product.
• Switch the product off immediately if you are disturbed
while working by other people entering the working area.
Always let the product come to a complete stop before
averting your attention.
• Do not overwork yourself. Take regular breaks to ensure you
can concentrate on the task at hand and have full control
over the product.
m
WARNING!
In some countries, regulations define
restrictions for use of such products, including the times and
days when operation is permissible. Ask your community for
detailed information and observe these regulations in order
to preserve a peaceful neighborhood and avoid committing
administrative offences.
Fig. 8
Extension cord
restraint hook
Extension cord
Appliance
cord
Fig. 9
Safety lock button
Trigger switch