SNOWJOE sunjoe SPX2600, Руководство оператора

Страница: 11 / 21

10
2. Gently pull the onboard detergent tank out of its storage
position. Remove the cap with PVC tube and fill the tank
with detergent designed specifically for use with pressure
washers (Fig. 18).
3. Insert the suction tube back into the tank and cap the
tank closed. Push the tank back into storage position on
the unit.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
4. Turn on the pressure washer. Pull the trigger to operate
the unit. The liquid detergent will automatically mix with
water and be discharged through the nozzle.
5 Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
6. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
7. Rinse with clean water under high pressure. When working
on a vertical surface, rinse from the bottom up, then rinse
from the top down to avoid streaking. Hold the nozzle 6-8
inches away from the work surface at a 45° angle.
8. When you have finished using the detergent injection
system, remove the detergent suction tube from the
detergent tank and insert it into 1.3 gal (5 L) of fresh water.
Siphon water at low pressure for one minute so that all
the detergent is flushed through the system. Remove the
detergent tank and rinse it until it is thoroughly cleaned.
m
CAUTION!
Failure to follow these cleaning
instructions will cause the injection system to become
clogged and inoperable.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.
Using the Wheel + Rim Brush
Sun Joe
®
universal pressure washer wheel and rim brush
is ideal for cleaning wheel rims and spokes on vehicles,
motorcycles, bicycles and more. Compatible with all Sun Joe
®
SPX series pressure washers.
1. If not already done, detach your spray wand from your
trigger gun (Fig. 19).
2. Take the wheel + rim brush and align the two tabs with the
inside of the trigger gun.
Fig. 17
Open to apply detergents
Fig. 18
Detergent tank
Pressure washer
detergent
Fig. 19