SNOWJOE Sunjoe SPX2002-MAX-RM, Руководство оператора

Страница: 13 / 20

13
3. Disconnect the spray wand from the trigger gun by
pressing it in firmly and twisting clockwise until the 2
locking tabs of the lance can be removed from the slot
(Fig. 21).
4. To connect the foam cannon with the trigger gun,
press the locking tabs of the foam cannon into the slot
of the trigger gun, then twist counterclockwise until the 2
parts are completely locked (Fig. 22).
5. Turn on the pressure washer. Pull the trigger to operate the
unit. The liquid detergent will automatically mix with water
and be discharged through the nozzle.
NOTE: The spray angle can be adjusted from pencil jet to
fan spray by rotating the foam cannon nozzle. The foam
volume can be adjusted by rotating the adjustable cap, as
indicated below (Fig. 23).
m
WARNING!
Do not adjust the foamer cannon while the
trigger is squeezed. Failure to do so could result in damage.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
6. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
7. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
8. When finished using the pressure washer, you must first
drain and rinse the foam cannon bottle. Run the pressure
washer until all of the soap is drained from the foam
cannon bottle.
m
CAUTION!
Failure to follow these cleaning instructions
will cause the injection system to become clogged and
inoperable.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage
the cleaning surface.
Using the Wheel + Rim Bristle Brush
Sun Joe
®
wheel + rim bristle brush safely cleans painted,
topcoat, and delicate surfaces. Compatible with all Sun Joe
®
SPX series pressure washers.
1. If not already done, detach your lance from your trigger
gun (Fig. 21).
2. Take the wheel + rim bristle brush and align the two tabs
with the inside of the trigger gun (Fig. 24).
3. Once aligned, push the wheel + rim bristle brush into the
trigger gun, twist counterclockwise to lock into place.
Fig. 21
Press the lance inside
1
Twist the lance as shown
2
Fig. 22
Trigger gun
Foam cannon
Locking tab
Fig. 23
Adjustable cap
Decrease
soap volume
Increase soap volume
Adjustable
nozzle
Pencil jet
Fan spray
Fig. 24
Wheel + rim
bristle brush
Locking tab