SNOWJOE Sunjoe MJ501M, Руководство оператора

Страница: 6 / 12

6
3 After assembling the handle, line up the holes at the lower
end of each handle arm with the short posts that extend
from the side plates of the mower base (Fig. 3).
4. Pull both sides of the lower handle bars over the posts
on the mower body. Press inward on the handle bars to
ensure a secure fit over the posts.
Fitting the grass catcher
1. Hook the pre-assembled grass catcher onto the mower
body by connecting the hooks to both ends of the steel
shaft (Fig. 4).
2 . Secure the locking strap on the grass catcher to the center
bar on the lower handle of the mower. Adjust the strap to
an appropriate height so that the grass catcher does not
rub against the ground while mowing or transporting the
unit (Fig. 5).
NOTE: If you have any questions, please call the Snow Joe
®
+
Sun Joe
®
customer service department at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
Operation
Cutting height adjustment
1. The cutting height of the 18" (45.7 cm) reel mower can be
adjusted from 1.4" to 2.5" (3.6 cm to 6.4 cm) by moving
the 9-position height adjustment levers to the desired
setting. The height adjustment levers are located next to
the smaller wheels.
2. In order to set the mower to its lowest cutting position,
pull the adjustment levers on both sides, one at a time,
and set them to position A (Fig. 6).
3. In order to set the mower to its highest cutting position,
move the adjustment levers on both sides to
position B (Fig. 6).
NOTE: The two adjustment levers MUST be set to the
same position (height).
Fig. 3
Post
Handle bars
R
Fig. 4
Steel shaft
Hook
Hook
Locking strap
Fig. 5
Highest
cutting
position
Lowest
cutting
position
Adjustment
Lever
Fig. 6
Position A
Position B