SNOWJOE Sunjoe 24V-PS10-LTE-RM, Руководство оператора, Страница: 11 / 24

11
Charging the Battery
1. Push the push lock buttons on the battery to pull the
battery pack out from the battery compartment (Fig. 1).
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
3. The battery will take approximately 5 hours to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery
m
WARNING!
This charger does not automatically
turn off when the battery is fully charged. Please take care
not to leave the battery plugged into the charger. Switch
off or unplug the charger at the mains when charging is
complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Assembly
m
WARNING!
Unpacking and assembly should be
completed on a flat and stable surface, with adequate space
for moving the machine and its packaging.
m
DANGER!
Never start the motor before installing the
guide bar, chain, and chain/sprocket end cover. Without all
these parts in place, the clutch can fly off or explode, exposing
the user to potentially serious injuries.
Installing/Replacing Guide Bar +
Cutting Chain
m
WARNING!
Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and efficiency of the
machine. If in doubt, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the pole chain saw
is disconnected with the battery before proceeding with
installation.
NOTE:
When you first purchase your chain saw, the chain
will come separately in the chain + bar box. Refer only to the
instructions for fitting the chain and bar (from step 5). Should
you need to replace the chain and bar in the future, follow all
the steps detailed below.
1. Unscrew the end cover knob counterclockwise to unlock
and remove the chain/sprocket end cover (Figs. 3 to 4).
Fig. 1
Battery pack
Fig. 2
Battery
indicators
R
Chain/sprocket
end cover
Fig. 3
End cover knob
Chain/sprocket
end cover
Fig. 4