SNOWJOE SUNJOE 24V-AJC-LTE, Руководство оператора

Страница: 11 / 20

11
Digital Gauge
The digital gauge on the air compressor is multifunctional. It
serves as a pressure gauge, monitors the amount of pressure
being applied to the item being inflated.
To switch from PSI, BAR, or KPA.
1. With gauge ON, press the power button to select the
desired measuring unit (Fig. 9).
To set pressure gauge for automatic shut off:
1. With gauge ON, press and hold down [ + ] or [ – ] buttons
to select desired shutoff pressure (Fig. 10).
NOTE: Numbers will flash while setting pressure. Holding
buttons down will make the pressure number increase
faster.
2. When desired setting has been selected, begin inflating.
Air compressor will shut off once setting is reached.
LED Light (Fig. 11)
The air compressor is equipped with a LED light above the
trigger switch to provide additional lighting for operation in
low light conditions. The LED light will turn on when the power
button [ ] is pressed and will stay on for 30 seconds.
St Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 12).
2. Place air chuck over valve stem and press down, readout
will appear on gauge (Fig. 10).
3. To turn the air compressor ON, press and hold the power
button [ ] below the LCD display (Fig. 9).
NOTE: The digital gauge will automatically shut off when
not in use for 30 seconds or more.
4. With gauge ON, select the desired shutoff pressure by
pressing [ + ] or [ – ] buttons (Fig. 10). Once it is set, wait a
few seconds until the current tire pressure displays.
NOTE: Always check and follow the manufacturer’s
recommended pressure, usually located on the door jamb
of your vehicle.
NOTE: Should the pump fail to reach the desired pressure
setting within 15 minutes, the pump will automatically shut
off.
PSI
BAR
KPA
Fig. 9
Air pressure
measurement
units
Power button
PSI
BAR
KPA
0.0
Fig. 10
Air pressure
(+) Button (–) Button
Fig. 11
LED light
Fig. 12
Battery
Battery
compartment