9
3. To use the nozzle without the brush, press the release
button and slide the brush up (Fig. 9).
m
WARNING!
Do not adjust the 2-in-1 brush
attachment while the tool is switched on. Doing so could result
in injury.
Operation Tips
m
WARNING!
Use the cordless handheld vacuum only in
daylight or good artificial light.
• Make sure the dust tank with the HEPA filter is properly
installed and secured when using. Failure to properly
secure the assembly could cause the dust tank and the
HEPA filter to release from the equipment.
• Double check to make sure the HEPA filter is not broken
or torn. Do not use filter that are broken or torn. Handle
the filter carefully when removing and installing.
• This unit is intended for indoor use only. Do not use this
unit outdoors.
• Be extremely careful when working on slopes and stairs.
• Clean up after using the handheld vacuum. Dispose of
debris appropriately.
m
WARNING!
To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Basic Vacuuming Procedure
• Always hold the unit on the handle when the vacuum is
on.
• During vacuuming, keep the nozzle at a distance of
approximately 0.4 inch (1 cm) above the material to be
vacuumed.
NOTE: The cordless handheld vacuum is equipped with
working overheating protection. When the temperature is
too high during vacuuming, the circuit will cut off and the
vacuum will stop working. If this happens, DO NOT press
the On/Off button any more. Let the vacuum cool down
for a while before resuming working.
• Turn off the unit after vacuuming, before cleaning and
maintenance. Empty the dust tank, clean and dry the
inside and outside before storage.
• Empty the dust tank outside in order to avoid a mess.
• Clean or change the filter (see Maintenance section) if the
suction performance deteriorates.
m
WARNING!
Never remove the dust tank without first
switch off the equipment.
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe
®
AJV1000 cordless handheld vacuum, please visit
sunjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
Cleaning The Dust Tank
1. Take the unit outside to clean it to avoid creating a mess
indoors.
2. Remove and empty the dust tank. Clean the tank with
water and allow it to dry completely.
Cleaning/Changing The Filter
The HEPA filter included is made of high quality material
designed to stop small dust particles. The filter should be used
for dry pick-up only. Handle the filter carefully when removing
it for cleaning and replacing. Check the filters for tears or
small holes, a small hole can let dust pass through and out of
the cleaner. Do not use a filter with holes or tears, replace it
immediately.
1.
Remove and empty the dust tank. Lift the HEPA filter up
from the dust tank.
2.
Clean the filter by gently tapping or brushing dirt off.
3.
If needed, rinse the filter with clean water. Allow the filter
to air dry for 24 hours before installing onto the vacuum.
4.
If the filter is torn and cannot be used anymore, insert a
new filter into the dust tank and attach the dust tank onto
the vacuum (Fig. 7).
Fig. 8
2-in-1 brush attachment
Fig. 9
Nozzle Brush
Release button
