14
Replacing the Belt
m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
1. Disassemble the left side cover by removing the
five (5) screws that hold it in place (Fig. 10).
2.
To remove the old belt from the drive wheel, use one hand
to slowly turn the auger while use the other hand to lift the
belt (Fig. 18).
3. Replace a new belt in place. Place the left side cover back
into position and refasten the five (5) screws.
Replacing the Scraper Bar
m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
1.
Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper bar to the base of
the unit (Fig. 19).
2.
Remove the old scraper bar (Fig. 20).
3. Install the new scraper bar and fasten it securely to the
housing with the four (4) screws (Fig. 21).
Lubricating the Cordless Snow Shovel
This cordless snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
Storage
1.
Examine the cordless snow shovel thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Remove the battery from the cordless snow shovel
before storing.
3. Store the cordless snow shovel indoors
in a locked, dry
place out of the reach of children to prevent unauthorized
use or damage.
B Charger Off-Season Storage
1.
Do not expose your battery pack or charger to water,
rain or allow them to get wet. This could permanently
damage the charger and the battery pack. Do not use oil
or solvents to clean or lubricate your battery pack as the
plastic casing can become brittle and crack, causing a
serious risk of injury.
2. Store the battery pack and charger at room temperature
away from moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other battery
pack types, permanent capacity loss can result if the pack
is stored for long periods of time at high temperatures
(over 120ºF/49ºC).
Fig. 18
Auger
Drive
wheel
Belt
Fig. 19
Remove
the screws
Fig. 20
Scraper bar
Fig. 21
Fix with
the screws
