Lit. No. 74258, Rev. 01
9
December 15, 2019
MOUNTING THE SPREADER
9. Remove the spreader from the vehicle bed and
drill 1/2" holes at the marked locations.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
10. Install the spreader to the vehicle using the
supplied 1/2" x 3" carriage bolts and 1/2" locknuts.
11. Tighten all fasteners according to the torque chart.
12. Install the four ratchet straps as shown below.
NOTE: It is important for safety that this strapping
method be used as the standard mounting
procedure.
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
Cross straps from
upper left to lower
right and from upper
right to lower left.
Run strap from rear of
vehicle to front corner
of spreader frame (both
sides of spreader).
Содержание V-Pro 32300
Страница 2: ......