Lit. No. 72107, Rev. 02
19
November 15, 2018
MAINTENANCE
LUBRICATION
To keep your spreader running smoothly, observe the
following recommendations:
• Lubricate bearings after every 20 hours of use.
• Apply a small amount of light oil to latches as
needed.
AFTER FIRST USE
Tighten all nuts and fasteners on spreader and mount.
AFTER EACH USE
• Wash unit after each use to prevent material
build-up and corrosion.
• Apply dielectric grease on all electrical
connections to prevent corrosion.
WARNING
Never remove the spreader with material in
the hopper.
CAUTION
• Do not modify vehicle or spreader wiring
harness. Doing so will void product warranty.
• When replacing parts use only original
manufacturer's parts. Failure to do so will void
warranty.
• The control is a solid-state electronic unit and
is not serviceable. Any attempt to service will
void warranty.
• There are no serviceable parts in the
motor/transmission assembly. Any attempt to
service will void warranty.
• When pressure washing motor enclosure
area, keep spray at least 36" away from motor
enclosures.
• Vibrator and spinner motor are not designed
for continuous duty. Allow motor to cool
between long cycle times.
CAUTION
Disconnect electric power at spreader
electrical wiring harness connection and tag
out if required before servicing or performing
maintenance.
CAUTION
DO NOT leave unused material in
hopper. Material can freeze or solidify,
causing unit to not work properly.
Empty and clean after each use.
CAUTION
When servicing is necessary, perform it in a
protected area. Do not use power tools in rain or
snow because of danger of electrical shock or
injury. Keep area well lit. Use proper tools. Keep
the area of service clean to help avoid accidents.
