SnowEx SP-8550, Руководство владельца/оператора

Страница: 30 / 37

© Trynex International 2010
Model # SP-8550
1 — 29
Troubleshooting
Loose electrical connections.
Blown Fuse.
Motor Seized.
Jammed auger.
Poor electrical connections.
Electrical short.
Controller failure.
Empty hopper.
Wet material.
Frozen or coarse material.
Spinner not turning.
Auger loose on shaft.
Vibrator not working.
Jammed auger, overload shut down.
Short in system.
Motor is not getting power.
Vehicle battery is extremely low,
or a poor connection exists.
Whenever service is necessary, your local SnowEx Dealer knows your Spreader best. Take your Spreader to your local dealer for any
maintenance or service needs on your unit. If this is not possible, the Troubleshooting Guide below may assist you in identifying the
problem.
Warning: First read all warning instructions and safety messages before servicing your spreader.
Preliminary Checks
• Be sure all electrical connections are tight and clean.
• Be sure nothing is jammed in the hopper.
Motor doesn’t run.
Controller shut down.
Material not owing
from hopper.
Audible alarm beeping and
display shows OL or OH.
Audible alarm beeping
display shows E1.
Audible alarm beeping
display shows EO.
Audible alarm beeping
display shows LB.
Check all connections.
Replace fuse.
Replace motor.
Carefully clear jammed material.
Clean or replace connectors.
Use dielectric grease.
Check electrical connections.
Check for bare wires.
Replace controller.
Fill hopper.
Replace with dry material.
Replace material.
Check drive assembly.
Tighten locking bolt on the side of the auger. There is a at
machined on the driver shaft. Align the auger with this at
and tighten the bolt.
Replace vibrator
Turn for three seconds, then restart. If shut down
continues, turn controller. Clear debris and lumps from
auger areas.
Turn . Do not use until problem is corrected.
Turn . Check all connections.
Turn . Charge battery.
PROBLEM POSSIBLE CAUSE SOLUTION
Rev. 01